Connecting A Lead Or Extension To The Ipg - St. Jude Medical GII Proclaim Manual De Instrucciones

Generador de impulsos implantable
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Insert and remove the pocket sizer to ensure that the pocket is large enough to accommodate
3.
the IPG, allowing enough extra room for a strain relief loop for each lead or extension.

Connecting a Lead or Extension to the IPG

The following steps outline the suggested guidelines to connect a lead or extension to the IPG:
CAUTION: Do not connect a lead or extension with body fluid or saline residue on its
contacts because corrosion can occur and cause failure of the system.
If any of the lead or extension contacts came in contact with body fluid or saline, thoroughly
1.
clean the contacts with sterile deionized water or sterile water for irrigation and dry them
completely.
CAUTION: Observe these cautions when performing the following step:
 Do not bend the lead sharply or it may be damaged.
 Do not loosen the setscrew in the connector more than a quarter turn at a time
while trying to insert the lead. Retracting the setscrew too far can cause the
setscrew to come loose and make the connector assembly unusable.
Using clean gloves, carefully slide the proximal end of the lead or extension into the IPG header
2.
until it stops. When the lead or extension is correctly inserted, the contact bands on the lead or
extension are fully inside the connector assembly and the windows between each of the header
contacts are clear.
Figure 2. Insert the lead or extension fully into the IPG header
CAUTION: Use only the torque wrench that is compatible with the IPG or the device
may be damaged and rendered unusable.
Insert the torque wrench through the septum and tighten the setscrew, turning it clockwise until
3.
the wrench clicks.
ARTMT100140147B.pdf 11
1. Fully inserted
2. Not fully inserted
3. Window between each header contact is clear
4. Window between each header contact is partially
blocked by contact band
7
5/2/2016 3:20:10 PM

Publicidad

Tabla de contenido
loading

Tabla de contenido