Replacing The Oscillating Quartz - Krömker UltraNeb Instrucciones De Uso

Faults, trouble-shooting
The device does not work / the red lamp lights up
The nebuliser chamber is inserted incorrectly.
☞ Insert the nebuliser chamber correctly. Note the
preferred position.
The nebuliser chamber is empty.
☞ Top up the nebuliser liquid.
The nebuliser chamber is leaking.
☞ Screw the oscillating quartz firmly into the
nebuliser chamber.
The oscillating quartz is defective.
☞ Replace the oscillating quartz.
The thermal switch has triggered.
☞ Leave the device to cool down. The device is
functional again after approx. 10 minutes.
The electronics are defective.
☞ Have the device repaired.
Misting too low despite setting to maximum
nebuliser output.
The nebuliser liquid is off the scale.
☞ Adjust the level of the nebuliser liquid to the scale
(top up or remove nebuliser liquid).
The resistance of the filter is too high.
☞ Replace the filter.
There is condensate in the tube.
☞ Drain the condensate.
Guide the tube such that condensate flows back
into the nebuliser chamber.
The tubes or the cover of the nebuliser chamber are
leaking.
☞ Put the cover on tightly and secure it with a
retainer.
☞ Push the tubes firmly onto the grommets.
No nebulisation is taking place.
The oscillating quartz has failed.
☞ Change the quartz module.
Contact water missing.
☞ Top up the contact water.
☞ Check the chamber for leak-tightness.
An accumulation of condensation water in the
nebuliser tube prevents aerosol flow.
☞ Drain the condensate water.
D „6.4 Preparing the USV 2010" (Seite 41).
The bacteria filter or tubes are incorrectly fitted.
D „6.4 Preparing the USV 2010" (Seite 41).
If it is not possible to remedy a fault:
☞ Contact the device supplier.
96200-114 – 10 – 15.07.2020
8.2

Replacing the oscillating quartz

☞ Screw a new oscillating quartz (C) into the
nebuliser chamber until the oscillating quartz
is firmly seated and the edge of the nebuliser
chamber is flush with the lower edge of the
quartz module.
47