Warning Messages - John Bean B 2000P Manual Do Operador

6-45.a
1
6-46
112
"BALANCE WITH RUNOUT"
For measurements straddling the limit value, the
Possible Problem indication is displayed.
If no problems are found with the wheel, tire or rim,
the OPTIMA ENTRY screen page shows "OK" (Fig.
6-45.a).
The appearance of the messages is linked to the
limit values set, which the operator can change
using the Optima Settings menu (Section 10).

6.4.3 Warning Messages

Wheel assembly problems messages appear
when:
or
2
Alert Message
If no matching is recommended:
High runout on wheel, but no possibility of improving
by matching. Check rim and tire for defects.
If matching is recommended:
High runout on wheel. Geometric matching is
recommended.
Warning Message
Possible issue with wheel, but no possibility of
improving by matching. Check rim and tire for
defects.
If matching is recommended:
Potential problem on the wheel. Check rim and tire
for defects.
Rim problems messages appear when:
a) wheel peak-to-peak runout is high
b) wheel 1-harmonic runout is high and the
proportion of runout between rim and tire
is close to 50 per cent.
(1,
Fig. 6-46):
(2,
Fig. 6-46):
1) rim radial runout is high
or
2) rim lateral runout is high
or
3) wheel 1-harmonic runout is high and the
proportion of runout between rim and
tire is greater than 60 per cent (high rim
1-harmonic runout).
.. ..........
_