John Bean B 2000P Manual Do Operador página 76

6-11
3
4-12
6-10
6-11
76
4
"MANUAL MODE"
6.1.4.1 Saving a Wheel Profi le
Up to 9 wheel profi les can be saved.
Clamp the wheel you wish to save the profi le of.
—
Set and acquire all the wheel data including
—
the number of spokes if an Alu P is required.
In the RIM DATA ENTRY screen select the
—
"SPECIAL" key (Fig. 6-11).
The WHEEL PROFILES screen (Fig. 4-12) will open.
The current wheel profi le data is highlighted in a line
on its own at the bottom of the page.
In the 9 position list, choose the current profi le
—
registration position.
Press the (3, Fig. 4-12) key to save data.
—
The data is now saved permanently in the chosen
position and can be recalled when required.
Note:
If the profi le is overwritten with other data it is no longer
shown in the list.
6.1.4.2 Recalling a Wheel Profile from the
memory
Clamp the wheel to the balancer.
—
In the RIM DATA ENTRY screen select the
—
"SPECIAL" key (Fig. 6-11).
The WHEEL PROFILES screen (Fig. 4-12) will open.
Type on one of the nine lines to select the
—
profi le indicated for the wheel on the machine.
Press the (4, Fig. 4-12) key to apply the
—
selection.
The ENTERING RIM DATA screen (Fig. 6-10) will open
and show the data recalled.
Check that the settings in the Indications Field
—
and Status Bar panel are correct.
The machine is now ready to proceed with the
measuring run.
.. ..........
_