John Bean B 2000P Manual Do Operador página 164

6-90
6-102
164
"OPTI LINE"
Start a new Set of Wheels
After entry of WHEEL No. 5 in a Set, you can start
a new Set, without exiting the Set of Wheels mode.
1
Proceed as follows:
• Perform the procedure as described for wheel
The machine deletes the data relative to the previ-
ous wheels and shows the current wheel as the first
wheel in a new Set.
After entry of WHEEL No. 4 in a Set you can start
a new Set, without exiting the Set of Wheels mode.
Proceed as follows:
Wheel number 5 is shown on the screen page (Fig.
6-102).
The machine deletes the data relative to the previ-
ous wheels and shows the last wheel as wheel
number 1, starting a new Set of Wheels.
4
5
6
Terminate and exit procedure
To exit the Set of Wheels procedure and return to
the OPTIMA ENTRY screen page.
All data relative to the Set of Wheels is deleted.
No. 1.
Mount the wheel on the balancer shaft.
•
Perform the run.
•
Complete any normal correction and
•
balancing operations required.
Remove the wheel from the balancer.
•
Access the "Set of Wheels" screen (1, Fig.
•
6-90).
Select key 4.
•
Press key 5 (Fig. 6-102).
•
.. ..........
_