salmson SIE Serie Instalacion Y Puesta En Servicio página 108

English
8.6.5 Calling up information
4.1.0.0
12.3
Fig. 40: Calling up information
8.6.6 Activating/deactivating service
mode
8.6.7 Activating/deactivating access
disable
98
Changes cannot be made in "Information" menu elements. These are
identified on the display by the default "access disable" symbol. To
4.1.1.0
call up current settings, proceed as follows:
5,4
• Navigate to the desired "Information" menu element (<4.1.1.0> in the
H/m
example).
The current value or state of the setting and the associated symbol
4.1.3.0
are displayed. Pressing the white button has no effect.
320
• Turn the white button to access the "Information" menu elements in
P/W
the current sub-menu (see Fig. 40). For an explanation of the settings
represented by the symbols, see the table in chapter 8.7 "Menu ele-
ments reference" on page 99.
• Turn the white button until the "One level up" menu element is dis-
played.
• Press the white button.
The display returns to the next higher menu level (<4.1.0.0> here).
Additional settings can be made in service mode. The mode is acti-
vated or deactivated as follows.
CAUTION! Risk of property damage!
Improper setting changes can lead to pump operation errors, which
can lead to material damage to the pump or system.
• Settings in service mode should only be made during commission-
ing and only by qualified personnel.
• Set DIP switch 1 to the ON position.
ON
Service mode is activated. The symbol shown here flashes on the sta-
1
tus page.
The sub-elements of menu <5.0.0.0> switch from the "Information"
element type to the "Selection/setting" element type, and the stand-
ard "access disable" symbol (see symbol) is hidden for the respective
elements (except for <5.3.1.0>).
The values and settings for these elements can now be edited.
ON • To deactivate, return the switch to its starting position.
2
In order to prevent impermissible changes to the pump settings, all
functions can be disabled.
When access is disabled, this is shown on the status page by the
default "access disable" symbol.
To activate or deactivate this, proceed as follows:
ON • Set DIP switch 2 to the ON position.
Menu <7.0.0.0> is displayed.
2
• Turn the white button to activate or deactivate the disable.
• To confirm the change, press the white button.
The current state of the disable is represented on the symbol display
by the symbols shown here.
Salmson 12/2017