SWM RS 650 R 2016 Manual De Uso Y Mantenimento página 97

REASSEMBLING THE FRONT WHEEL
Fit the L.H. spacer (D) on the wheel hub.
RS: Fit the wheel between the fork legs so as to set
the brake disc into the calliper.
SM: Fit the wheel between the fork legs.
Fit the wheel axle (2) from the R.H. side, after greas-
ing it and push it fully home against the L.H. fork leg;
during this operation, the wheel should be turned.
Tighten the screw (3) on the fork L.H. side but DO
NOT lock it.
Now, pump for a while, pushing the handlebar
downwards until you are sure that the fork legs are
perfectly aligned. Lock: the screws (1) on the R.H. leg
(7.67 ft-lb), the screw (3) on the L.H. side (37.95 ft-lb),
the screws (1) on the L.H. leg (7.67 ft-lb).
SM: fit the brake calliper on the disc; assemble the
calliper on its mounting plate and tighten the two
screws (A) at 25.5 Nm/ 2.6 Kgm/ 18.8 ft-lb. Ensure
that the brake disc slides between the calliper pads
without any friction or hard spots.
D
1
Note*:
After reassembly, pull the brake control lever until
the pads are against the brake disc.
2
3
A
1
EN - 39