Noise Level; Technical Specifications - spanesi BTPLUS Manual De Instrucciones De Uso Y Manutención

1.11 NOISE LEVEL

PONYBENCH BTPLUS's noise level was measured with the control pumps operating, load-free under normal operating
conditions. Measurements were taken to conform to EN ISO 3746/1996 standard by a competent laboratory using a
precision integrating phonometer. The test results are indicated below:
Average sound pressure level LpAm
Sound pressure at operator's post LpA
Sound power level LwA

1.12 TECHNICAL SPECIFICATIONS

The essential data are shown in the table. For more detailed information on product characteristics, contact the
manufacturer directly.
SPECIFICATION
Max. capacity of lift without pull system
Max. capacity of lift equipped with pull arm
Max. height (without pads)
Length of upper mobile platform
Width of upper mobile platform
Length of base frame
Width of base frame
Operating pressure of lift hydraulic circuit
Operating pressure of pull arm pump hydraulic circuit
Operating pressure of pneumatic supply circuit
Weight of lift complete with accessories without pull system
Weight of standard pull arm with accessories
Ascent time
Descent time
Three-phase power supply version
Single-phase power supply version
Power supply frequency
Three-phase electric motor power
Auxiliary circuit voltage with 400 V three-phase power supply
Auxiliary circuit voltage with 230 V single-phase power supply
Control unit weight
Weight of lift complete with accessories and pull system
dB(A)
dB(A)
dB(A)
60
PONYBENCH BTPLUS
MEASURE VALUE
kg 3000
kg 2700
mm 1420
mm 2210
mm 700
mm 2185.5
mm 630
bar 270
bar 500
bar 8
kg 610
kg 172
sec 46
sec 49
volt 400 A.C.
volt 230 A.C.
hertz 50
kW 1.5
volt 24 A.C.
volt 230 A.C.
kg 50
kg 782
68.1
88.3
78.4