Installing The Pull Bar On Ponybench Btplus - spanesi BTPLUS Manual De Instrucciones De Uso Y Manutención

Idiomas disponibles

4.9 INSTALLING THE PULL BAR ON

PONYBENCH BTPLUS

DANGER! Before performing any pulling

operation YOU MUST lock all four support

��

arms in their opening position by tightening

��

the four securing screws (Figure 4 No.12 ).

If these screws are not tightened, this could

cause the arm to break while pulling and put

at risk the safety of the operator or of persons

close to the work station, and also endanger

the vehicle lifted by the bench.

��

When you desire to apply the pulling arm to the

PONYBENCH BTPLUS it is necessary to do as it follows:

��

•

make the lift descend to the fi rst section, proceeding

��

as described in paragraph Descent to fi rst section .

��

•

pull the <open-close> push-button of the pull bar

��

locking pistons (Figure 4 No.12 ) in order to withdraw

��

the locking cylinder Figure 10 No.3 ).

��

•

Take the pulling bar from the zone where it was left

temporarily, take it to the front or rear part of the lift,

��

according to need, where the support is located, and

push it in order to insert the block (Figure 10 No.1 ) in

� ��

its seat ( Figure 10 No.2 ).

��

•

pull the <open-close> push-button of the pulling bar

�

��

locking pistons ( Figure 4 No.12) al fi ne di in order

��

to return the locking cylinder (Figure 10 No.3 ) in

��

tightening position and, in this way, ensure that the

pulling bar is secured to the lift.

�

��

�

��

�

��

�

��

�

��

�

��

Figure 4-

DETAIL

��

Figure 10

��

Tabla de Contenido

Installing The Pull Bar On Ponybench Btplus - spanesi BTPLUS Manual De Instrucciones De Uso Y Manutención

Capítulos

Productos relacionados para spanesi BTPLUS

Installing The Pull Bar On Ponybench Btplus - spanesi BTPLUS Manual De Instrucciones De Uso Y Manutención

Idiomas disponibles

Capítulos

Manuales relacionados para spanesi BTPLUS

Productos relacionados para spanesi BTPLUS