Periodically; Rest Periods; Replacing The Seed Plate; 10Recommended Lubricants - GASPARDO ORIETTA OLIMPIA Instrucciones De Uso

5.0.7 PERIODICALLY

- Check the pressure of the seed drill tyres:
tyres 5.00-15 (2,2 bar).

5.0.8 REST PERIODS

At the end of the season, or if a long period of rest is foreseen it
is advisable to:
- Wash the equipment thoroughly with water, especially the
chemical substance hoppers, then dry them.
- Carefully check for worn or damaged parts and replace then
where required.
- Adjust the belt of the diffusion air pump and and replace it if
necessary.
- Firmly tighten all screws and bolts.
- Oil all the drive chains and apply lubricant to all unpainted parts.
- Protect the equipment with a (nylon) cover.
- Then position it stably in a dry place out of the reach of
unauthorized people.
It is in the interests of the user to follow these instructions carefully,
as when work recommences, he will find the equipment in perfect
condition.

REPLACING THE SEED PLATE

5.0.9
All operations described in this paragraph must be carried out
by expert personnel, equipped with protective gloves, in a clean
and dust-free environment.
- The seeder must be clean and dry and stably positioned.
If the power take-off is hooked to the tractor it must be
disconnected, the engine turned off, the key removed and the
hand brake pulled.
- Only clean parts in good condition must be installed.
- The disk must be assembled with the hole countersink turned
towards the distributor cover.
- If there are circular scratches, they must not exceed 1/3 of
the plate thickness.
N.B. When replacing worn plates, the cover gasket should also
be replaced.
REPLACING THE COVER SEAL
Check the whole of the seed distributor cover seal surface
regularly (A, Fig. 58) for signs of wear.
The seal must be replaced before the surface «A» (Fig. 58),
being worn down by the disc movement, reaches surface «B».
Also check that no grooves have been made by the disk along
surface «A».
5.0.10 RECOMMENDED LUBRICANTS
For lubrication in general, we advise:
OLIO AGIP BLASIA 460 SAE 85W/140 or equivalent, for
specification see last cover page.
For all greasing point we advise:
GRASSO AGIP GR MU EP 2 or equivalent, for specification see
last cover page.
cod. G19502812
CAUTION
USE AND MAINTENANCE

6.0 DEMOLITION AND DISPOSAL

This operation is to be carried out by the customer.
Before demolishing the machine, you are advised to carefully
check its physical condition and ascertain whether there are any
parts of the structure that may be susceptible to structural collapse
or breakage during demolition.
The customer should operate in compliance with the environment
protection laws in force in his/her country.
The machine demolition operations should be carried out by
skilled personnel only, equipped with suitable protective
clothing (safety footwear and gloves) and auxiliary tools and
equipment.
All the disassembly operations for demolition should be carried
out with the machine stopped and detached from the tractor.
Before demolishing the machine, you are advised to render
harmless all the parts that may be a source of danger and
therefore:
- scrap the structure using specialized firms,
- remove any electrical apparatus according to the laws in force,
- collect oils and greases separately, to be disposed of through
specialized firms, in accordance with the regulations of the
country in which the machine was used.
When the machine is demolished the CE mark should be
destroyed together with this manual.
A
B
fig. 58
g
ENGLISH
CAUTION
CAUTION
B
A
77