First-Time Setup - Riester ri-medic Manual De Instrucciones

The Riester ri-medic must be placed on a stable, slip proof surface. Only recommended hardware should be used to mount your
device to a wall, pole or tabletop carrier.
At no point should the contents of the storage basket exceed five lbs. in weight.
Do not immerse the device in water or attempt to gas sterilize or autoclave it.
The reliability of your Riester ri-medic depends upon conformance with the operation and service instructions as detailed in this
manual.

4.4 FIRST-TIME SETUP

The product is in sleep mode when it leaves the factory.
The product is in sleep mode when it leaves the factory. It should be
It s hould b e activated only b y the end user s hortly
activated only by the end user shortly before first use. Otherwise the
before first use. Otherwise the rechargeable battery can
rechargeable battery can be damaged by depth discharge.
be damaged by depth discharge.
For activation the device must be plugged in
For activation the device must be plugged in
and charged before first use!
a.) Charging the Battery
The Riester ri-medic Battery is powered by a rechargeable 6V lead-acid battery or by AC power. To turn the device on for the
first time, connect the device to the power supply, then the power supply to an AC mains power source. Leave it connected for
8 to 12 hours to fully charge the battery.
The charging status is indicated by the rotating sequence of lit segments
charged, all segments will be lit
measurements within a 12-hour period. The battery is guaranteed to last for 200 readings in an 8 hour period per charge.
b.) Connecting Your Device
Connectors on the BP enclosure are for:
Blood pressure hose
Power supply
To connect the Riester ri-medic:
For blood pressure measurements, the blood pressure hose should already be attached to the BP device. If not, push the
open end of the blood pressure hose (one without the plastic connector) over the blood pressure hose connector on the mo-
dule. Secure the end with the plastic connector to an appropriately sized
cuff by twisting the two mating connectors together.
Connect the power supply to the main BP module. Then, connect the power supply to an AC mains power source. The device
will turn on automatically.
4.5 POWERING UP
a.) Depress the power button. The power-up sequence begins. All display segments light up for three seconds. A short beep
indicates that the Riester ri-medic is ready.
b.) Check the status of the power level indicator. If the power level indicator shows one segment flashing, connect the device to
the power supply before using. You are now ready to use your Riester ri-medic.
Bluetooth® Wireless Communication
If your Riester ri-medic has the optional Bluetooth® wireless communication capability, please contact your IT administra-
tor for configuration with your EMR/HER system or communication network.
and charged before first use!
. A fully charged battery provides enough power for the device to make at least 200
in the battery icon. When the battery is fully
13