Transport, Assembly, Putting Into Operation And Decommissioning; Transport; Assembly (Built-In Appliances Only); Unheated Appliances (Ebs/50-50 And Ebs-T/50-50) - Hupfer Korbstapler KO/50-50 Manual De Instrucciones

Transport, Assembly, Putting into Operation and Decommissioning

Transport

4 Transport, Assembly, Putting into Operation and Decommis-
sioning
4.1 Transport
ATTENTION
4.2

Assembly (Built-in appliances only)

The following section describes the assembly of the built-in basket dispenser.
Primarily, the unheated appliances EBS/50-50 and EBS-T/50-50 are described that do not require any elec-
trical installations after the assembly.
Subsequently, there follows an assembly description of the heated appliances EBSH/50-50 and EBSH-T/50-
50, which must be connected to the power supply after the assembly is finished.
4.2.1

Unheated Appliances (EBS/50-50 and EBS-T/50-50)

NOTE
Figure 3
4330007_A0
Appliance damages caused by improper transport
In the case of off-site transport in a vehicle such as a lorry, the appliances
should be secured properly. The total brakes are not sufficient as a transport
securing method.
If the appliances are not secured properly, there is a risk of damage to prop-
erty and persons caused by squashing.
During transport, secure all the individually standing appliances using corre-
sponding transport securing devices.
Appliance location
Built-in appliances may only be used after being retrofitted or built-in (e.g. in a
cabinet).
Worktop cut-out EBS/50-50
KO/50-50 | KO/65-53 | KO/50-50K | KO/65-53K | KOUH/50-50 | KOUH/65-53 | EBS/50-50 | EBS-T/50-50 | EBSH/50-50 | EBSH-T/50-50
Chapter 4
Page 19
Basket Dispenser