Hupfer Korbstapler KO/50-50 Manual De Instrucciones página 60

Chapter 4
Page 22
There is a connecting cable set with a wiring diagram attached to the built-in heated appliances.
The set consists of a connecting cable with a Schuko® plug and a connecting cable with an appliance plug
arranged on the appliance. The connecting cables are wired up via the on/off switch with an integrated indi-
cator light.
Figure 7
Figure 8
Step 1: Preparation

Prepare cut-outs in the worktop and the front cladding corresponding to the indicated dimensions.
The worktop cut-out dimensions are given in mm as shown in the corresponding drawing of the built-
in appliance. The cut-out dimension for the switch is 1.18'' x 0.87'' (30 x 22 mm).

Remove the protective plastic film from the metal plates.
Basket Dispenser
KO/50-50 | KO/65-53 | KO/50-50K | KO/65-53K | KOUH/50-50 | KOUH/65-53 | EBS/50-50 | EBS-T/50-50 | EBSH/50-50 | EBSH-T/50-50
Worktop cut-out EBSH/50-50
Worktop cut-out EBSH-T/50-50
Transport, Assembly, Putting into Operation and Decommissioning
Assembly (Built-in appliances only)
4330007_A0