h. sAfeTY WArnings
Caution:
Clean your helmet carefully!
For cleaning instructions see section I.1. (maintenance and care –
Outer helmet shell) of this manual.
Caution:
Do not carry the helmet on the motorcycle's helmet storage lock
while riding in order to avoid exhaust pipe burns, tire abrasion,
and strap damage to the helmet.
Caution:
Keep the helmet outside the reach of pets to avoid the helmet
being damaged by chewing, scratching or other mistreatment.
2. SAFETY ADVICE CONCERNING THE FACESHIELD / SUN
VISOR
Warning:
Keep your helmet (faceshield and sun visor)
in good condition!
If your faceshield or sun visor become too scratched or
uncleanable, replace it with a new one. Impaired visibility causes
accidents. Clean your faceshield and sun visor only with mild
soap diluted in tap water. Rinse well with clean tap water, and
dry with a soft cloth. Never use benzene, gasoline, glass cleaner
or any other solvents. Do not attach stickers or adhesive tape
to the faceshields and sun visor, as this will weaken the hard
coating, damaging them. Do not drive with a dim or blurred
shield. Impaired vision can cause an accident resulting in serious
personal injury or death.
Warning:
Remove protective film before using the helmet!
The protective film fastened to the faceshield to protect it from
scratches in transit must be removed before use.
54
Warning:
Keep the helmet away from aggressive substances.
Motor fuel and solvent vapor can cause the faceshield and sun
visor to crack. Keep the faceshield and sun visor away from such
vapors and do not allow kinds of substances to come into direct
contact with the faceshield or sun visor! For that reason, never
place the helmet on the tank of your motorcycle.
Warning:
Don't ride when visibility is poor!
Make sure the faceshield and sun visor are always in perfect
condition. If for any reason, the visibility is poor, don`t ride.
Warning:
Don't ride with a fogged up faceshield.
Never try to manually clean a fogged up faceshield while riding,
this could cause an accident resulting in serious personal injury
or death. In light stages of misting you may either open the chin
ventilation or the faceshield to the town position. If the fogging is
not immediately reduced stop your ride.
3. SAFETY ADVICE CONCERNING MODIFICATIONS /
ACCESSORIES
Warning:
Do not modify your helmet.
Original parts (especially on the outer shell, inner shell and
retention system) must not be modified or removed. The fitting of
non-genuine, non-recommended parts can partially or completely
counteract the protective function of the helmet and invalidate the
DOT approval with all guarantee and insurance claims.
Warning:
Use only original parts.
Use only replacement parts and accessories expressly made for
your helmet by SCHUBERTH!
55