Publicidad
Idiomas disponibles
Idiomas disponibles
4.3
Functions/key features
Automatic recharging of batteries, regardless of the battery's depth
of discharge.
Charging process starts automatically once battery is connected
Soft charge start for low grid load and automatic time delay when
operating multiple chargers
Compensation of supply voltage fluctuations of ± 10 %
Detection of a battery that is already charged
Automatic transition into top-up charging mode to compensate for
self-discharging after charging is complete
Intelligent safety shut-off in response to battery defects
Charging even if one power output stage should fail, provided more
than 1 power module is available
5
Transport
The charger is supplied packaged in a box on a pallet.
CAUTION
!
Risk of injury!
Read and adhere to the labelling on the
packaging
NOTE
Damage to the device and the environment!
Read and adhere to the labelling on the
packaging
Only store the charger in dry areas.
During transport, make sure that the pallet containing the charger does
not tilt.
The tilting indicator provides information on potential toppling incidents.
In the event of a red signal, proceed
as follows:
1. Do not reject the delivery.
2. Note the red indicator on the
delivery/transport note and check
the goods.
3. If damage has occurred, leave all
items in their original packaging
and request a damage inspec-
tion within 3 days following the
delivery.
22
6
Installation and
initial commissioning
The charger can be set down, or positioned on a load-bearing,
non-flammable wall using the wall bracket (available as an option).
WARNING
!
Contact with live parts!
Danger to life, or very serious injuries due to
electrocution.
During installation work, disconnect the
power plug
Do not connect any battery
NOTE
Risk of fire!
Do not place any objects on the charger
!
Do not stack chargers
Prevent excessive dust exposure at the
installation position
Prevent conductive dust (from rust and
metals)
6.1
Installation
Position the charger on a firm, level surface. The flow of air through the
openings on the underside of the device to the rear side must not be
obstructed.
When installing the charger, make sure that there is a clearance of at least
5 cm to the left, right, and rear of the device in order to ensure adequate
ventilation.
Always install the device at a higher level than the top edge of the battery.
In dusty environments, the charger must always be mounted on the wall
and a dust filter must be used.
6.2
Charging cable
The charging cable set supplied (red: + and black: -) has a guided
strain-relief mechanism at the connection to the charger. On the
battery side, the cable must be provided with a suitable plug-in connector
for connection to the battery socket.
Electrical resistance across the length and cross section of the supplied
charging cable is considered within device configuration.
Publicidad
