Final Installation - Harbor Breeze SAWGRASS Manual Del Usuario

FINAL INSTALLATION

1. Locate two canopy mounting screws (N) on
underside of mounting bracket (C) and remove
canopy mounting screw (N) closest to the open
end of the mounting bracket (C). Partially loosen
the other canopy mounting screw (N). Lift canopy
(B) to mounting bracket (C). Place rounded part of
slotted hole in canopy (B) over loosened canopy
mounting screw (N) in mounting bracket (C) and
push up. Twist canopy (B) to lock. Re-insert
canopy mounting screw (N) that was removed,
and then tighten both canopy mounting screws
(N). Slide canopy cover (I) up to canopy (B),
aligning rounded part of slotted holes in canopy
cover (I) with screwheads in bottom of canopy (B).
Turn canopy cover (I) to the right (clockwise) until
it stops. (Fig. 1)
Partially insert three blade screws (AA), along with
2.
three rubber blade washers (BB), to attach one
blade arm (F) to a blade (G). (Make sure to
attach blade (G) with ridged side facing up and
flat side facing the blade arm (F). Note label
indicating THIS SIDE UP.) Then, tighten each
blade screw (AA) starting with the one in the
middle. (Fig. 2) Repeat with remaining blades (G).
Hardware Used
Blade Screw
AA
BB Rubber Blade Washer
3. Locate motor screws (J) and lock washers (K) that
were removed in Step 5 on page 7.
Insert two motor screws (J), along with lock washers
(K), through one blade arm (F) to attach blade arm
(F) to motor. Tighten motor screws (J) securely.
(Fig. 3) Repeat with remaining blade arms (F),
making sure to completely secure each blade arm
(F) before proceeding with the next.
1
N
2
x15
x15
3
12
I
A
AA
F
K
J
B
BB
G
G
F