Thus prepared draft shield and panes can be properly cleaned. All the operations should be done
carefully. Pay special CAUTION to the spot where the weighing pan was installed: dirt and other
small elements might enter the balance construction through this opening, which might negatively
influence the balance parameters.
Undo
protection, next slide the pane out of
a guide bar.
Remove the back pane.
Remove side panes.
Side panes shall not be swapped
therefore it is necessary to remember
which one is right, and which one is
left in order to install them back
properly.
CAUTION! Do not remove the front pane!
Remove a weighing pan, a draft
shield, a bottom insert. Clean the
components when detached. With this
your balance mechanism is protected
against accidental damage.
- 15 -
and
remove
top
pane