Checkweighing; Declaring Threshold Values - RADWAG R Serie Manual Del Usuario

•
The balance software automatically enters <PARTS COUNTING> mode displaying the number
of pieces which are on the pan (pcs). In the bottom line, a single piece mass value is shown (if
the option has been selected for <INFORMATION> function)

11.4. CHECKWEIGHING

Checkweighing is a working mode that uses two thresholds (LOW and HIGH) in order to check mass
of the samples. It is generally assumed that the mass is correct if it is contained within the threshold
values.
F Shortcut Keys
You can declare which particular weighing function is to be launched using F1, F2, F3 or F4 keys.
For procedure informing you how to declare the particular function, read F Shortcut Keys section.

11.4.1. Declaring Threshold Values

Procedure:
•
Press F button to which the function <ASSIGN THRESHOLDS> is assigned, the editing
window is displayed and the value of MIN low threshold can be ascribed. The ascribed value
must be given in a current unit.
•
Use arrow buttons to enter low threshold value, press
•
The software automatically proceeds to the editing window of MAX high threshold value, which
is to be given in the current unit. Use arrow buttons to enter high threshold value, press
button to confirm.
•
The balance software proceeds to <CHECKWEIGHING> mode, values of declared thresholds
are displayed in the bottom line (if such an option has been selected for <INFORMATION>
function).
•
At the top of the display the message <Min> is shown, it indicates weight value placed on the
weighing pan in relation to low limit weight value. Bottom line of the display, if <BARGRAPH>
option is enabled, shall demonstrate weight indication, in a graphic form, in relation to set
thresholds.
<Min>: mass lower than the value of the low threshold
button to confirm.
- 52 -