Setting The Reference Mass: Entering Mass Value - RADWAG R Serie Manual Del Usuario

Ocultar thumbs Ver también para R Serie:
Tabla de contenido

Publicidad

Use arrow buttons
For optional quantity variable (displayed value <0000>) enter any number using arrow buttons
Confirm selected sample quantity, confirmation message - <PLACExx PCS> - shall be seen.
Place the declared number of pieces in the container and when the result is stable (the symbol
is displayed) confirm the mass by pressing
The balance software automatically counts a single piece mass and enters the mode <PARTS
COUNTING> displaying the number of pieces which are on the pan (pcs). In the bottom line, a
single piece mass value is shown (if the option has been selected for <INFORMATION>
function).
CAUTION!
Remember that:
The total mass of all the pieces put on the weighing pan must not be greater than the balance maximum
weighing range.
The mass of a single piece cannot be lower than 0.1 reading unit of the balance. If this condition is not
met, the balance displays message: <Single part mass too low>.
While determining the number of pieces, wait for the stability pictogram
You can confirm the declared quantity by pressing
displayed. Otherwise, the balance will not accept the measurement.

11.3.3. Setting the Reference Mass: Entering Mass Value

Procedure:
Press F button to which the function <ENTER SAMPLE> is assigned, wait to see the editing
window <ENTER SAMPLE>
Use arrow buttons to enter the known weight value of a single piece.
or
to select the correct sample quantity.
- 51 -
button,
, next confirm the quantity.
button only after the stability pictogram is

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

As r2Ps r1Ps r2Ps r2.hApp r

Tabla de contenido