Hard Wire Installation - Thermo Scientific ThermoFlex Manual De Instrucciones

Hard Wire Installation

Thermo Scientific
For personal safety and equipment reliability, only a qualified
technician should perform the following procedure.
Note The technician is responsible for installing circuit protection for
incoming power. Before wiring consult the nameplate on the rear of the
chiller. Ensure installation is in accordance with the National Electrical Code
and any other applicable country and local codes.
Figure 3-2 Electrical Box
• Remove the six screws securing the electrical box cover to the rear of
the chiller.
• Remove the double knock out (
• Insert the cable through the hole.
• Refer to the label in the electrical box to configure your chiller, see
Figure 3-3.
• Secure the cable's ground wire to the ground stud.
• Reinstall the cover.
Figure 3-3 Sample Label
(2)
(2)
Terminal Block
(2)
Ground Stud
/ " and 1
7
8
Section 3


Knock Out
/ ").
3
32
ThermoFlex 3-9