Initial Start Up - Thermo Scientific ThermoFlex Manual De Instrucciones

Section 4
Initial Start Up Only
CAUTION
Thermo Scientific
• Place the circuit protector located on the rear of the chiller
to the up position.
• Press the
The controller will display the quick start screen that will allow you
to configure the chiller. Refer to the Quick Start Guide supplied with
the chiller or the copy located after the Table of Contents.
Press the arrows to scroll through and highlight each line of the
display. If a change is needed from the factory default value press
the enter button.
If the auto restart is enabled and the chiller shuts down as a
result of a power failure, when power is restored the chiller will
automatically restart and operate at the saved values. Consider
any possible risks before enabling this mode of operation.
Note The chiller will not automatically restart if the Show Quick
Start was enabled, see page 4-20. In this case only the controller is
powered.

If satisfied with all the entries, press enter when the last line
- Quick Start Done - is highlighted. If not satisfied, press the left
arrow, or esc button, to leave the quick start display.
In either case the screen will go blank.
If enter was pressed, press
displays and start the chiller. See next page.
button on the controller.
to bring up the Daily Start Up

ThermoFlex 4-2