Set Up; How To Use - Hutchinson Technology InSpectra StO2 650 Manual Del Usuario

InSpectra StO
™
1. Confirm that the following components are present:
InSpectra StO Tissue Oxygenation
1
2
Monitor with permanently attached
optical cable
2
InSpectra StO Sensor
™
3
2
Power cord
4
InSpectra StO System Check
™
5
2
InSpectra StO Case Graphing
™
6
2
Software User Manual
InSpectra StO Model 650
™
7
2
User Manual
2. Record the Serial Number, located on the
back of the monitor in the upper right corner,
on the inside front cover of the User Manual.
3. Record the Purchase or Acquisition Date in
the section provided inside the front cover of
the User Manual.
Set-Up
The InSpectra StO Tissue Oxygenation Monitor can be set on a flat surface next to the patient or mounted on
™
2
an IV pole using the C-clamp located in the recessed cavity
side of the monitor opens and closes the clamp. To mount on IV pole:
1. Turn knob counter clockwise to open the C-clamp
2
2. Position on the pole.
3. Turn knob clockwise to tighten the C-clamp and secure the monitor on the IV pole.
O
WarNING: To ensure patient safety:
• S ecure the InSpectra StO
Monitor tightly to the IV pole.
• D o not place the InSpectra StO
Oxygenation Monitor in any position that might
allow it to fall on the patient.
• C arefully route cabling to reduce the possibility
of patient entanglement or strangulation.
• P ossible tripping hazard. Do not allow the
InSpectra StO Monitor Optical Cable to lie on
2
the floor where it may become damaged or pose
a tripping hazard.
cautIoN:
• R epeated exposure to ionizing radiation can
cause cumulative damage to the InSpectra
StO Monitor Optical Cable glass fibers resulting in inaccurately low InSpectra StO
2
avoid damage to the Optical Cable, whenever possible:
• Position the Optical Cable out of the direct X-ray imaging area.
• D isconnect and position the Optical Cable out of the CT imaging area.
• P ossible inaccurate measurements. Do not lift or carry the InSpectra StO
the optical cable; doing so could result in damage to the cable and inaccurate measurements.
Tissue Oxygenation Monitor
2
6
Tissue Oxygenation
2
Tissue
2
1
3
7
in the back of the monitor. A knob
1
completely.
1
2
Tissue Oxygenation Monitor by
2
4
2
5
figure 9.1
on the right
2
1
figure 9.2
System Readings. To
2
9

How To Use