Patient Monitoring - Hutchinson Technology InSpectra StO2 650 Manual Del Usuario

InSpectra StO
™
To begin patient monitoring, an InSpectra StO
be connected to the optical cable and adhered to patient
tissue. See placement instructions on the next page.
The Sensor has the following parts:
Connector
1
Sensor shield
2
connect the InSpectra Sto
Remove the InSpectra StO
Align the two raised lines on the optical cable connector and the
1
raised line on the sensor connector.
Insert the sensor connector into the optical cable connector with
2
the raised lines aligned.
Rotate the collar towards the locked symbol to close.
3
The "Sensor connected" message will display on the screen
4
in the status bar and the system is now ready for
patient monitoring. The sensor does not require
calibration.
Delete all Historical Data
The prompt, "Delete all historical data?" will
appear immediately in the data display area
allow save or deletion of historical data stored in the
monitor from a previous use.
This message will appear when:
1
• A sensor is initially connected or reconnected to the
optical cable.
• T he monitor is powered up with a sensor
already connected.
• T he Delete Data menu is selected from the
Set Up / History menu.
S elect Yes to clear all historical data.
2
Select No if you are resuming monitoring on
3
the same patient and/or wish to save previous
patient data.
Selecting Home is the same as No, and returns to
4
the main menu.
16

Patient Monitoring

Sensor
2
Sensor must
2
Sensor
2
Sensor from the package.
2
to
1
1
4
1
2
3
2
figure 16.1
1 2
figure 16.2
4
figure 16.3
3