Publicidad
F4
Remontagem da placa porta-patim esquerda
Insira a anilha original (F2) no parafuso especial (F1).
Posicione o grupo placa porta-patins esquerdo (F) no perno do
braço oscilante (M) e encoste o parafuso especial (F1).
Encoste o parafuso original (F3) colocando a anilha original (F5)
entre a placa porta-patins (F) e o cárter.
Encoste o parafuso especial original (F4).
Aperte o parafuso especial (F1) e os 2 parafusos especiais (F3) e
(F4) ao binário indicado.
8
M
F3
F5
F4
LH footpeg holder plate refitting
Fit original washer (F2) onto special screw (F1).
Position LH footpeg holder plate unit (F) on swingarm shaft (M) and
start special screw (F1).
Start original special screw (F3) after placing original washer (F5)
between footpeg holder plate (F) and casing.
Start the original special screw (F4).
Tighten special screw (F1) and no. 2 special screws (F3) and (F4) to
the specified torque.
F
F2
F1
55 Nm ± 5%
F3
36 Nm ± 10%
36 Nm ± 10%
ISTR 725 / 00
Publicidad
