CT Xarrier TOP X Manual Del Usuario página 11

(Fig. 14.1÷14.5) tied onto the metal ventral attachment element. Attention! Never
use any attachment point that is different from those indicated (Fig. 14.7÷14.8).
Attention! Always check thoroughly the knot before starting to climb.
10.2 - Use with equipment. The harness must be secured to a belay or lowering
device via a connector that is equipped with a locking screwgate (Fig. 14.6).
Make sure that the connector is correctly locked and that it is loaded on the major
axis.
10.3 - Techniques. The harness is intended for mountaineering activities, including
rock climbing. It can be used for belay manoeuvres, abseiling, via ferratas etc.
11) ADDITIONAL WARNINGS. 1) Gear loops are to be used only to hang
materials. Do not use for other purposes (fastening, abseiling etc.). Attention! The
horizontal webbing located on the shoulders are designed exclusively to insert the
Hook Rest support (Ref. No. 6V522) and should not be used for other purposes
(Fig. 13.1-16). The Hook Rest support is exclusively designed for the positioning
of a fall arrester lanyard while not in use. (Fig. 17). It is designed to release the
connector if subjected to a load exceeding a few kilograms, so that it does not
interfere with the opening of the energy absorber in the event of a fall (Fig. 17.5).
2) Inert suspension in the harness can cause serious physiological injuries and, in
extreme cases, fatality. Attention! Take all the necessary preAttentions to minimize
the likelihood of an inert suspension and its duration.
12) SYMBOLS. Refer to the legend in the general instructions (paragraph 16): F1.
Climbing Technology by Aludesign S.p.A. via Torchio 22
24034 Cisano B.sco BG ITALY
www.climbingtechnology.com
Member of
IST52-7H180CT_rev.0 10-21
11/55