Section 2: Unpacking And Inspection; General; Required Tools; Unpacking - Generac G0062700 Directrices De Instalación

Section 2: Unpacking and Inspection

General

NOTE: After unpacking, carefully inspect the contents for
damage. It is advised to unpack and inspect the unit
immediately upon delivery to detect any damage that
may have occurred in transit. Any claims for shipping
damage need to be filed as soon as possible with the
freight carrier. This is especially important if the generator
will not be installed for a period of time.
•
This standby generator set is ready for installation
with a factory supplied and pre-mounted base pad
and has a weather protective enclosure that is
intended for outdoor installation only.
• If any loss or damage is noted at time of delivery,
have the person(s) making the delivery note all
damage on the freight bill or affix their signature
under the consignor's memo of loss or damage.
• If a loss or damage is noted after delivery, separate
the damaged materials and contact the carrier for
claim procedures.
• "Concealed damage" is understood to mean
damage to the contents of a package that is not
evident at the time of delivery, but is discovered
later.

Required Tools

• General SAE and Metric hand tools
– Wrenches
– Sockets
– Screwdrivers
•
Standard electrician's hand tools
– Drill and bits for mounting and routing conduits
•
4mm Allen wrench (for access to customer
connections)
• 3/16 Allen wrench (test port on fuel regulator)
• Manometer (for fuel pressure checks)
• Meter capable of measuring AC/DC Voltage and
Frequency

Unpacking

1. Remove cardboard carton.
2. Remove the wood frame.
Installation Guidelines For 50 Hz Air-Cooled Generators
Figure 2-1. Crated Generator
3. Remove bolts and pallet brackets (A). Exercise
caution when removing the generator. Dragging it
off the pallet will damage the base. The generator
must be lifted from the wooden pallet to remove.
Figure 2-2. Generator on Pallet
4. The lid will be locked. A set of keys is attached to
the circuit breaker box door with a cable tie. Cut the
cable tie to remove the keys. Use the keys to open
the lid of the generator.
Unpacking and Inspection
000427
000426
A
7