Before Initial Start-Up; Installation Wizard - Generac G0062700 Directrices De Instalación

Generadores enfriados por aire de 50 hz
Ocultar thumbs Ver también para G0062700:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Control Panel/Start-Up/Testing
NOTE: The exercise feature will operate only when the
generator is placed in the AUTO mode and will not work
unless this procedure is performed. The current date/time
will need to be reset every time the 12 volt battery is
disconnected and then reconnected, and/or when the
fuse is removed.

Before Initial Start-up

NOTE: These units have been run and tested at the
factory prior to being shipped and do not require any type
of break-in.
CAUTION
Engine damage. Verify proper type and quantity of
engine oil prior to starting engine. Failure to do so
could result in engine damage.
Language
Defaults to English
if not selected.
+ English -
+ Espanol -
+ Francais -
+ Portuguese -
Use UP and DOWN
ENTER
arrows to select fuel
type then press
"ENTER"
Fuel Selection
+ NG or LP -
Set Output Voltage
- 220V +
- 230V +
- 240V +
Cold Smart Start?
ENTER
YES or NO
Note: If language was previously programmed this goes directly to "Select Hour"
Select Hour (0-23)
ENTER
- 14 +
*
* Holding the Up or Down arrow
button for 2 seconds will speed dial
through the selections
Install Wizard
ENTER
Set Exercise
26
(000135)
Power Up Unit
FIRMWARE V 1.01
HARDWARE V 1.05
Install Wizard
ESC
Cold Smart Start?
- YES or NO +
Select Min (0-59)
Select Month (1-12)
ENTER
- 0 +
*
Select Frequency
ENTER
- WEEKLY +
- BIWEEKLY +
- MONTHLY +
Figure 7-2. Installation Wizard Menu Map
NOTE: This unit comes filled with 30 weight organic oil
from the factory. Check the oil level and add the
appropriate viscosity and amount if necessary.

Installation Wizard

Upon power-up, the Installation Wizard immediately
appears. It allows the user to input generator settings.
Figure 7-2.
The Installation Wizard will start every time AC and DC
power are removed and re-applied to the generator.
Select Date (1-31)
ENTER
- 2 +
*
Select Hour (0-23)
ENTER
- 14 +
*
Switched to "OFF"
ENTER
Hours of Protection
0 (H)
Installation Guidelines For 50 Hz Air-Cooled Generators
+
UP ARROW =
DOWN ARROW =
Select Year (0-99)
ENTER
- 13 +
- 13 +
*
Select Min (0-59)
Select Day
ENTER
- 0 +
- Wednesday +
*
SYSTEM
DATE/TIME
SUB MENUS
BATTERY
-
*
*
001407

Publicidad

Tabla de contenido
loading

Tabla de contenido