Publicidad
Man. 630-2004-IMP. I-2
27-07-2004
MAINTENANCE
Maintenance recommendations
This fork is the result of years of experience made on the most important racing
tracks. Even though it is a high technology product, no particular maintenance is
needed. Since it is designed for a sporting use, maintenance is very easy to
perform and needs no special tools.
Routine maintenance
1- Dust seal cleaning:
2- Oil change:
3- Oil seal change:
4- Air bleeding:
Note: reference numbers in this chapter refer to the parts belonging to the fork
exploded view on page I.10.
1- Dust seal cleaning (FIG. 5)
NOTE
There is no need to disassemble the fork legs to clean the dust seal.
No special tools are required.
Use silicone grease spray.
PROCEDURE
Before cleaning the dust seal, clean the stanchion tubes
Remove the dust seal (12) from the slider (7). Do not score the stanchion tube (5-
6).
Lower the dust seal down the stanchion and clean the inner side of the dust seal
and its seat in the slider with compressed air.
Never use metal tools to remove the dirt. Pump the slider slightly up and down
and remove any possible dirt from the stanchions. Lubricate the dust seal and the
visible part of the oil seal.
Reposition the dust seal in the stanchion.
2- Oil change
NOTE
To change the oil, the fork legs must be disassembled.
Required tools: no. 2 19-mm Allen wrenches, scale or gauge.
Tightening torque for damper rod: 10 Nm.
Tightening torque for plug check nut: 30 Nm.
Tightening torque for slider plug: 25 Nm.
1.5 lt. of recommended oil.
N° 8000A3632 (06-04)
11:49
Pagina I.25
All manuals and user guides at all-guides.com
TELAIO, SOSPENSIONI E RUOTE
FRAME, SUSPENSIONS AND WHEELS
CHASSIS, SUSPENSIONS ET ROUES
RAHMEN, AUFHAENGUNG UND RAEDER
BASTIDOR, SUSPENSIONES Y RUEDAS
After every race
After 30 hours
After 30 hours
After every ride
FIG.5
I.25
Publicidad
Capítulos
