Storage - Stiga ZERO TURN MOWER Serie Uso Y Mantenimiento

4
1
1. Deck Spindle
2. Engine Drive Pulley
3. Deck Idler
4. PTO Belt
Figure 23
Install
(Figure 23)
NOTE: Do not install PTO belt on left mower
deck pulley in step 1.
1. Install PTO belt on engine drive pulley
and mower deck.
2. Rotate idler arm clockwise until PTO belt
can be routed around left mower deck
pulley.
3. Slowly release idler arm until idler pulley
rests firmly against PTO belt.
4. Install belt covers on mower deck.
NOTICE: Ensure that belt is still positioned in
the groove of the sheaves after belt covers
are installed.
REPLACING HYDROSTATIC
BELT
Remove
(Figure 24)
1. Remove PTO belt. See Replacing PTO
Belt on page 28.
CAUTION: Use care when
releasing idler spring tension.
Keep body parts well away from
idler when performing this
operation.
2. Disconnect idler spring.
2
1
Install
(Figure 24)
3
Short Term Storage
IMPORTANT: NEVER clean unit with high-
pressure water or store unit outdoors.
Remove all dirt, grease, leaves, etc. Store in
a clean dry area.
Inspect unit for signs of wear or damage.
Ensure all fasteners are properly tightened.
Long Term Storage
Follow all instructions under Short Term

Storage.

Remove and fully charge battery. Store in a
clean dry area.
Refer to Engine Manual for the proper engine
storage procedures.
Touch up all scratched or chipped paint
surfaces.
EN - 29
3. Remove hydrostatic belt from
hydrostatic transmission pulleys, drive
pulley, and idler.
1. Install hydrostatic belt on idler, drive
pulley, and hydrostatic transmission
pulleys.
2. Connect idler spring.
3. Install PTO belt. See Replacing PTO
Belt on page 28.
1
4
2
3
1. Hydrostatic Belt
2. Hydrostatic Transmission Pulley
3. Idler
4. Idler Spring
Figure 24
STORAGE
2