Preparing The Transmitter - Medtronic GUARDIAN 4 Manual Del Usuario

Figure 3. Components

Preparing the transmitter

The transmitter contains a non-replaceable, rechargeable battery that can recharge as needed with
the charger. The transmitter needs to be charged before use. The charger has a green light that shows
the charging status and a red light that communicates any problems during charging. If there is a red
light, see Troubleshooting, page 33. The charger requires one AAA alkaline battery.
Note: If the battery is installed incorrectly or is low, the charger will not work. Repeat the battery
installation steps using a new battery.
Installing a battery in the charger
To install a battery in the charger:
1. Push the battery cover in and slide it off (as shown in image A in step 3).
2. Insert a new AAA alkaline battery. Make sure the + and - symbols on the battery align with these
same symbols shown on the charger.
3. Slide the cover back on the charger until it clicks into place (as shown in image B in step 3).
transmitter
tester
charger
17