GRAPHITE 58G941 Manual De Instrucciones página 25

STARTING THE ENGINE
Hold the chain saw with both hands during operation.
●
Check level in the fuel tank and the oil tank.
●
Ensure the brake lever (
●
When engine is cold, pull out choke cable (
●
Set the ignition switch (
●
Place the saw on stable ground.
●
While holding the saw pressed against ground, pull the starter line (
gears, then pull it strongly (fig. D).
●
After starting the saw, press the throttle lever lock (
move automatically to switched off position).
●
Allow the engine to heat up with throttle lever (
●
Move the brake lever ( 6) to switched off position (to the back).
●
Make a cut.
In case the engine does not start at the first try, pull out the choke cable (2) halfway and pull the starter
line again.
After few failed attempts pump fuel with the membrane pump (26) and try again.
Do not start the engine while holding the saw in hands. During start up the chain saw must rest on
ground and be held firmly. Ensure the chain is free to move without touching any object. Do not cut
any material with choke cable pulled out.
STOPPING THE ENGINE
● Release the throttle lever (11) and allow the engine to run idle for a few minutes.
●
Set the ignition switch (
CHECKING CHAIN LUBRICATION
Check lubrication of the chain and oil level in the tank before starting to work. Switch on the saw and hold
it above ground. If you see enlarging oil marks, the chain lubrication works well (fig. E). If there are no oil
marks or they are very small, use oil feed adjustment screw (9) to make appropriate adjustments. In case the
adjustment brings no effects, clean oil outlet, upper hole of chain tension and oilway, or contact service.
Make adjustments when the saw is switched off, observe precaution measures and do not allow
the guide bar to touch ground. Operate the tool safely and maintain at least 20 cm distance from
ground.
Use oil feed adjustment screw (9) to set amount of supplied oil accordingly to respective operating
conditions.
●
MIN position – oil flow decreases.
●
MAX position – oil flow increases (
When cutting hard and dry wood and using whole length of the guide bar when making a cut, set the oil
feed adjustment screw (9) to the MAX position.
You can reduce amount of oil supplied by turning oil feed adjustment screw (9) to MIN position, when
cutting soft and damp wood, or when only part of the working length of the guide bar is used.
Depending on ambient temperature and amount of oil supplied, you can operate the chain saw for 15 to
40 minutes per one filling the oil tank (tank capacity is 160 ml).
Oil tank should be almost empty when the fuel tank is emptied. When filling the fuel remember
about filling oil tank as well.
CHAIN LUBRICANTS
Durability of chain and guide bar depends heavily on quality of lubricant. Use only lubricants, which are
designed for chain saws.
OPERATION / SETTINGS
6) is in the switched on position (moved to the front).
2).
14) to switched on position (fig. C).
11) slightly pressed.
14) to STOP position.
fig. F).
25
13). First slowly so to hear the clutch
1) and throttle level (11) slightly (choke cable will