Controls And Instru- Ments; English - Stiga SENATOR Manual De Instrucciones

GENERAL
This symbol indicates WARNING. Per-
sonal injury and/or damage to property
may result if the instructions are not
followed carefully.
You must read these instructions for use
and the accompanying pamphlet
"SAFETY INSTRUCTIONS" careful-
ly, before starting up the machine.
SYMBOLS
The following symbols can be found on the ma-
chine to remind you of the care and attention that
are required during use.
The symbols mean:
Warning!
Read the instruction manual and the safety
manual before using the machine.
Warning!
Watch out for discarded objects. Keep on-
lookers away.
Warning!
Always use hearing protectors.
Warning!
This machine is not designed to be driven
on public roads.
Warning!
The machine, equipped with original ac-
cessories, must not be driven in any direc-
tion on slopes with a gradient greater than
10º.
Warning!
Risk of crushing injuries. Keep hands and
feet well away from the articulated steer-
ing joint.
Warning!
Risk of burn injuries. Do not touch the si-
lencer/catalytic converter.
CONTROLS AND INSTRU-
MENTS
Items 1 - 20, see figures 1 - 9.
All manuals and user guides at all-guides.com

ENGLISH

1. IMPLEMENT LIFTER
(Senator - President - Royal - Pro16)
A pedal for raising front-mounted implement to
the transport position.
To lift up the implement, press the pedal down as
far as it will go. Then release the pedal, the imple-
ment lifter is now locked in the lift position.
To lower the implement, press the pedal down so
that the lock is released. Lower the implement lift-
er to the working position by slowly lifting your
foot from the pedal.
2. HYDRAULIC LIFTER (Pro20)
Hydraulic implement lifter for raising front-
mounted implement to the transport position.
The floating position, with the switch in the tilted
forward position, is recommended for normal use.
To secure the implement lifter, place the switch in
neutral.
3A. SERVICE BRAKE/CLUTCH
(Senator)
A pedal that combines both service brake and
clutch. There are 3 positions:
Note! You must never regulate the operating speed
by slipping the clutch. Use a suitable gear instead,
so that the right speed is obtained.
To raise the implement, press the rear
part of the switch. Release the switch
in the required position.
To lower the accessory, press the
front part of the switch. The switch
stays in the pressed position and the
implement lifter is lowered until it
reaches a floating position. This
means that the implement can follow
the contours of the ground.
1. Pedal released – forward drive
engaged. The machine will
move if a gear is engaged. Serv-
ice brake not activated.
2. Pedal depressed halfway –
forward drive disengaged, gear
shifting can be performed. Serv-
ice brake not activated.
3. Pedal fully depressed – for-
ward drive disengaged. Service
brake fully activated.
GB
55