Stiga SENATOR Manual De Instrucciones página 56

GB
3B. SERVICE BRAKE
(President - Royal - Pro16 - Pro20)
A pedal that acts upon the machine's braking sys-
tem. There are 3 positions:
1. Pedal released – service brake
not activated.
2. Pedal depressed halfway –
forward drive disengaged. Serv-
ice brake not activated.
3. Pedal fully depressed – for-
ward drive disengaged. Service
brake fully activated.
4. PARKING BRAKE
An inhibitor that can lock the brake pedal in the de-
pressed position.
Depress the brake pedal fully. Move the
inhibitor to the right and then release the
brake pedal.
The parking brake is released by pressing the brake
pedal. The spring-loaded inhibitor slides to one
side.
Make sure that the parking brake is released when
operating the machine.
5. DRIVE PEDAL (President - Royal -
Pro16 - Pro20)
A pedal that activates the variable transmission.
1. Depress the pedal with the
ball of your foot – the machine
moves forwards.
2. No load on the pedal – the ma-
chine is stationary.
3. Depress the pedal with your
heel – the machine reverses.
The drive pedal regulates the speed. The more
pressure applied, the faster the machine will move.
6. ADJUSTABLE STEERING WHEEL
(President - Royal - Pro16 - Pro20)
The steering wheel can be adjusted vertically in 5
positions. Press in the inhibitor on the steering col-
umn and raise or lower the steering wheel to the
desired position.
Do not adjust the steering wheel during opera-
tion.
56
All manuals and user guides at all-guides.com
ENGLISH
7. THROTTLE/CHOKE CONTROL
A control for setting the engine speed and to choke
the engine when starting from cold (the latter does
not apply to Pro16-Pro20 which have separate
choke control – see item 8).
8. CHOKE CONTROL (Pro16 - Pro20)
A pull-type control to choke the engine when start-
ing from cold.
Never operate the machine with the choke
pulled out when the engine is warm.
9. IGNITION LOCK/SPOTLIGHT
Ignition lock used for starting/stopping the engine.
Also includes switch for spotlight (Senator does
not have a spotlight). Four positions:
1. Choke – for starting a cold engine. The
choke is located in top of groove (does not
apply to Pro16-Pro20). Avoid operating
the machine in this position, taking care to
move the control to full throttle (see be-
low) when the engine is warm.
2. Full throttle – when the machine is in
operation, full throttle should always be
used.
3. Idling.
1. Control fully pulled out – choke valve
in carburettor closed. For starting cold en-
gine.
2. Control pushed in – choke valve open.
For starting warm engine and when oper-
ating the machine.
1. Stop position – the engine is short-
circuited. The key can be removed.
2. Operating position – spotlight activat-
ed.
3. Operating position – spotlight not acti-
vated.