Stryker Performance-PRO XT Manual De Uso página 45

To attach an oxygen bottle to the retractable head section oxygen bottle holder (Figure 34):
1. Center the oxygen bottle on the cradled surface of item (A).
2. Tighten both straps (B) around the oxygen bottle.
3. Secure the slack on the straps to the V V e e l l c c r r o o ® on the straps.
N N o o t t e e
• The Fowler oxygen bottle holder option (6500-241-000) is not compatible with the retractable head section oxygen bottle
holder option (6085-046-000).
• Do not use the oxygen bottle holder to hold an oxygen bottle holder when the transport vehicle is in motion. Always place
the oxygen bottle holder in an appropriate storage location when the transport vehicle is in motion.
• Inspect the straps and clips for wear between use. Replace the strap if it no longer holds the oxygen bottle.
A A t t t t a a c c h h i i n n g g t t h h e e b b a a s s e e s s t t o o r r a a g g e e n n e e t t o o p p t t i i o o n n
C C A A U U T T I I O O N N
• Do not load the base storage net above the safe working load of 20 lb (9 kg).
• Always be careful when you retract the base to avoid damaging items that are stored in the base storage net.
To attach the base storage net, wrap the V V e e l l c c r r o o ® straps around the base tubes.
A A t t t t a a c c h h i i n n g g t t h h e e b b a a c c k k r r e e s s t t s s t t o o r r a a g g e e p p o o u u c c h h
C C A A U U T T I I O O N N
• Do not load the backrest storage pouch above the safe working load of 20 lb (9 kg).
• Do not allow the storage pouch to interfere with the operation of the retractable head section.
To attach the backrest storage pouch (Figure 35):
1. Insert each strap through a hole in the backrest skin.
2. Mount the pouch flat against the backrest.
3. Secure the backrest storage pouch to the cot with the V V e e l l c c r r o o ® straps.
6086-209-005 Rev AA.0
B
A
F F i i g g u u r r e e 3 3 4 4 – – O O x x y y g g e e n n b b o o t t t t l l e e a a t t t t a a c c h h m m e e n n t t
41 EN