Publicidad
Idiomas disponibles
Idiomas disponibles
1. Two-way pump
2. Fluid container with a pass-through lid
3. Fluid container with a lid
4. Long hoses
5. Short hoses
6. Tips-adapters
3.2.
Preparation for operation
POSITIONING OF THE UNIT
The ambient temperature must not exceed 45°C and ambient humidity should not
exceed 85%. Do not block the air outlet of the unit. Keep the appliance away from
any hot surfaces. Always operate the device out of the reach of children and persons
with reduced mental, sensory and intellectual abilities.
3.3.
Working with the device
IMPORTANT: the pump works in a two-way manner, i.e. depending on the
application, it can generate positive pressure (e.g. for generating pressure in a
given system) and negative pressure (e.g. suction vacuum for pumping out liquids
from a given system). The kit includes various adapters for specific inputs, valves,
etc.
NOTE: An example of the use of a vehicle brake bleeding kit is described below (e.g.
when changing the brake fluid):
a) Place the vehicle securely on a workshop lift or supports so that it is level.
b) Remove the wheels from the hubs.
IMPORTANT: if the manufacturer of a given vehicle did not state
otherwise, the generally accepted rule for bleeding the brake system
during fluid replacement is that you start bleeding the brakes from the
wheel located farthest from the brake pump and gradually moving
towards it, i.e. ending with the wheel located closest to the brake pump.
However, it should be taken into account that the order of bleeding the
Publicidad
