Installation - JUKI LK-1941 Manual De Instrucciones

# . INSTALLATION

WARNING :
To prevent possible accidents caused by the fall of the sewing machine, perform the work by two persons
or more when the machine is moved.
(1) Set-up of the table
!1
Reference
1) Securely install control box 2, power switch 3, pedal switch 4, heater unit !3 and cable clamp !4 on
table (14117519) 1.
2) Connect the pedal with 4 the pedal switch using the chain !2 .
3) Securely fix the respective power cables with the staples.
4) Securely fix oil drain 7 on the table 1, and screw oil receiver 8.
5) Set cushion rubber 5 on oil pan 6, and fit oil pan 6 to the holes of the table hinges (4 places) 9. Then
fix oil pan 6 at 4 places with wood screws.
6) Close the center portion of oil pan 6 with the rubber plug after screwing it.
7) Strike head support bar !0 in the hole of table !1 .
1. Installation of 4 and !2 is for 1-pedal type only.
2. Installation of !3 and !4 is for Z type only.
4
5
6
!0
9
4
8
!2
Reference
Reference
!3 Reference
!4
7
3
1
2