Attaching The Needle - JUKI LK-1941 Manual De Instrucciones

20130424 LK-1941,1942 R08
Font bushing
4

2. Attaching the needle

WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
2
B
3
4
Intermediate bushing
5
1
A
3) Remove the top cover, and apply oil to front bushing
4 and intermediate bushing 5.
Be sure to perform the above 2) and
3) steps when the machine is first
installed, or when it is run after a
long period of disuse.
Loosen setscrew 1 and hold needle 2 with the long
groove facing toward you. Then fully insert it into the
hole in the needle bar, and tighten setscrew 1.
1. If the stitches are made as shown
in A, attach the needle facing to the
direction B to a small extent.
2. If the wiper interferes with the
needle, turn the hand pulley and
slightly lower the needle bar, or turn
the air cock 4of the filter regulator
and expel the air.
When using the needle other than the
one supplied at the time of delivery,
it may be necessary to replace the
hook. See the table of the gauge parts
on P62.
19