Winding The Bobbin; Removing The Bobbin; Setting The Spool Of Thread; For An Ordinary Spool - Janome 385.8080200 Manual De Instrucciones

Winding the Bobbin
Removing the bobbin
Slide the hook cover release button to the right, and
remove the hook cover.
Lift the bobbin out.
O Hook cover release button
(_ Hook cover
(_ Bobbin
Setting the spool of thread
Place the spool of thread on the spool pin with the
thread coming off the spool as shown.
• For an ordinary spool:
Use the large spool holder.
(_ Large spool holder
• For a narrow or small spool:
Use the small spool holder.
Small spool holder
Additional spool pin
Insert the additional spool pin and spool stand into the
hole on the machine. Place the felt and spool on the
spool pin as shown.
(_ Spool
(_ End of the thread
(_ Additional spool pin
'(_ Felt
Spool stand
Hole for the additional spool pin
Winding the bobbin
NOTE: winding.
Set the speed control lever at,_ for bobbin
[] Guide the thread around the bobbin winder thread
guide.
(_ Bobbin winder thread guide
[] Insert the thread through the hole on the bobbin,
threading from the inside to the outside. Put the
bobbin on the bobbin winder spindle.
(_ Bobbin winder spindle
[] Push the bobbin winder spindle to the right. The
LED display shows _.
[] With the free end of the thread held in your hand,
depress the foot control. Stop the machine when
the bobbin has made a few turns, and cut the
thread close to the hole on the bobbin.
[] Depress the foot control again. When the bobbin is
fully wound, it will stop automatically. Return the
bobbin to its original position by moving the spindle
to the left, and cut the thread as shown.
,.==_
[]
%
J
J
2O