Automatic Needle Threader; Drawing Up Bobbin Thread - Janome 385.8080200 Manual De Instrucciones

Automatic Needle Threader
[] Raise the needle to itshighest positionby pressing
the needle Up/Down button twice.
Raise the presserfoot.
Depressthe needlethreader knob as far as it will
go. The hookcomes out through the needle eye
from behind.
Q_ Needle threader knob
Q Hook
[] Draw the thread down around the threader guide
and under the hook.
(_ Threader guide
[] Release the threader knob slowly while holding the
thread end with your hand. A loop of the thread is
pulled up through the needle eye.
(_ Thread end
[] Carefully remove the loop from the threader and
pull out the thread end from the needle eye.
I OTE:
The automaticthreader works well with the threads
#50-100 and needles#11-16, the blue tipped
needle as well.
[]
[]
Drawing Up Bobbin Thread
[] Raise the presserfoot and hold the needle thread
with your fingers.
Q Needle thread
[] Press the needle Up/Down button twice to raise the
needle to its highest position. Pull the needle
thread to pick up a loop of the bobbin thread.
(_) Needle thread
_) Bobbin thread
Needle Up/Down button
[] Draw 10 cm (4") of both threads to the back under
the presser foot.
26