Publicidad
102
Trouble shooting
Code C21
This code provides information about the program
version and the balancer model name
—
Go into code C21.
Information about the software version appears.
—
Press the "-" key to view the Kernel version.
The information is visible as long as the key is pressed.
Press the "+" key or the "FINE" key to view the
—
balancer model.
Note: The information is visible as long as the key
is pressed.
FOR MACHINES WITH A POWER CLAMP ONLY
Code C22
Unclamping of power clamping device locked.
Releasing the power clamping device is disabled
Applies where another clamping device is fi tted,
which is held on the main shaft through the tie
rod (e. g. USV, SCA or motor-cycle wheel adaptor
"p").
0*
=
Unclamping enabled
1
=
Unclamping disabled
The mode C22, when changed, is transferred
automatically into the permanent memory and
will not even be changed again by choosing
the modes of operation as proposed by the
manufacturer.
Code C23
Allow unclamping of wheel only if imbalance
= 0 and OK.
0* = Unclamping always enabled
1
= Unclamping disabled if not 0 / OK
Code C26
Direction of actuation of pedal for clamping/
unclamping
0* = Clamping/unclamping by lifting the pedal
1 = Clamping/unclamping by depressing the
pedal
When changed, the mode of operation C26 can
be transferred into the permanent memory.
*
= Factory confi guration
Publicidad
