Publicidad
2
60
5-23
5-30
Operation
• Apply the weight in the correct position on the
wheel.
• Turn the wheel to the next WAP position (2 Figure
5.23).
• Apply the stick-on weight on the arm to the second
spoke; the weights will have been applied to two
contiguous wheel spokes.
• On completion, run a verifi cation measurement.
• Select Enter to exit from this Mode.
Select Enter several times (depending on the program
stage) to force the program to close. The original weight
for the right plane will still be displayed. The SWM
indicator will disappear and you will hear a brief beep.
The program returns to the main menu (Fig. 5-30).
Note:
There is no priority when applying split weights.
The operator can choose which to apply fi rst.
Warnings:
The measured unbalance value is only split into two
application points after the spoke positions have
been acquired.
When balancing with counterweights behind the
spokes, if an Optimisation/Minimisation is required,
run it before applying the weights.
Publicidad
