Publicidad
106
Trouble shooting
7.1.2
E codes
When the E code is displayed, a low beep is generat ed.
Whenever a code appears:
• note it down
• look up the codes in the list below. If the code is not
described, call service.
• perform the steps described.
The format of this section is:
Code
Description
• Step(s) to be performed.
Some error messages are displayed for approx. 3
seconds on the display on the right side.
• To clear the error code immediately (e.g.), open the
wheel guard or press the STOP key.
F
E 9 (
7.1.3)
E10
Gauge arm removed from idle position during wheel
rotation.
• Bring gauge arm to the idle position (home position).
• Perform a wheel run without touching the gauge
arm.
• If the error appears again, have the gauge arm
calibrated (by the service department).
Display clears after several seconds.
E11
During ignition the gauge arm is not in the idle position.
• Move the gauge arm back carefully to the idle
position.
The error should disappear within a few seconds.
• If the error appears again, contact the service
department.
Note:
By pressing STOP you can continue to
use the machine by entering wheel data
manually (
F
E 14 (
7.1.3)
F
E 21 (
7.1.3)
F
5.6.1).
Publicidad
