Grundfos CU 362 Instrucciones De Instalación Y Funcionamiento página 21

6.3.3 Communication
Go to the menu Settings > Communication settings.
The CU 362 must have a CIM module (Communication Interface
Module) fitted to be able to transfer data to the SCADA system or to
a mobile phone.
Various CIM modules are available, depending on the type of
network. The CIM module must be fitted directly in the CU 362. See
installation and operating instructions for the CU 362.
For configuration of the CIM module, see the installation and
operating instructions and the functional profile on the link/QR code
provided with the module.
6.3.4 Selecting the CIM communication module
In this display, you must select the CIM communication module
fitted in the CU 362.
Select each of the submenus, and enter the data required in each
menu. For further information, see Dedicated Controls, Software
description installation and operating instructions.
Each communication module has a series of configuration
submenus and special functions.
The CU 362 supports these CIM modules:
• CIM 200 (Modbus RTU via RS-485)
• CIM 260 (Modbus TCP and SMS via GSM/GPRS)
• CIM 280 (Grundfos Utility Connect)
• Other module (future communication modules).
The type of communication module used can be found on
the back of the CU 362.
Path:Settings > Communication settings >
Communication settings
Before inserting the SIM card into CIM 260 or CIM 280,
remove the PIN code, or set it to "4321".
Change the PIN code by inserting the SIM card into a mobile
phone. Consult your mobile phone manual for further details.
Configuration via network
When the CIM module fitted in the CU 362 has been configured, the
remaining configuration can be done using the established
communication line.
6.3.5 CUE or VFD installations
For details about the setup of the CUE and VFD, see Dedicated
Controls, Software description installation and operating
instructions and the installation and operating instructions for the
CUE or VFD.
Radio modem
If a radio modem is to be used as communication line, a CIM 200
Modbus module must be fitted in the CU 362.
The following has to be set:
• Modbus address
• Parity
• Modbus transmission speed.
See installation and operating instructions for the CIM 2XX Modbus
module.
The Modbus address set in the CIM 200 Modbus module has to be
set in the CU 362 as well.
1. Select "CIM 200".
2. Select the submenu "Fieldbus addresses".
3. Set the Modbus address in the line "CIM Modbus address".
Radio modem network
Pos. Description
1 SCADA
1
21