Vision Fitness ELLIPTICAL ERGOMETER S60 Manual Del Usuario página 6

NOTE: A second person will be helpful to complete this step.
3
• Place the left CONNECTION ARM (4) over the left arm and connect with 2 SOCKET
HEAD BOLTS (E). Tighten only a few turns with the 8MM L-SHAPED WRENCH.
• Insert the pin on the front flange of the connection arm to the hole in the console
mast elevation bracket.
• Repeat these steps on the right side.
• When the pins of both connection arms are seated in the holes of the console mast
elevation bracket lift the entire assembly slightly to line up the screw holes. Insert
4 SOCKET HEAD BOLTS (F) with 4 WASHERS (G) through these holes. Secure with
a WASHER (G) and NYLON NUT (H) to each bolt. Tighten with the 6MM L-SHAPED
WRENCH and 13MM WRENCH.
• Go back and completely tighten the screws that connect the connection arms to the
adjustable arm with the 8MM L-SHAPED WRENCH.
PINK BAG
Description
E M10x65L Socket Head Bolt
F M8x30L Socket Head Bolt
G 8.2x16x1.6T Washer
H M8 Nylon Nut
H
G
4
E
Qty
46.8N.m/ 34.6 ft-Ib 4
23.6N.m/ 17.5 ft-Ib 4
8
4
G
F
• Lift the left adjustable arm and insert the bearing end of the SUSPENSION ARM
2 4 (5) into the bracket of the adjustabl arm. From the outside, insert a HEX BOLT (K)
through the bracket and suspension arm.
• Secure with a LOCK WASHER (I) and NUT (J). Tighten with 2 19MM WRENCHES. Make
sure hardware is tight.
• Repeat this step on the right side.
BLUE BAG
Description
I M12 Lock Washer
J M12 Hex Nut
K M12x95L Hex Bolt
K
5
Qty
2
2
80N.m/59 ft-Ib 2
I
J
5