Publicidad
_!_ii<q,_xi_ix,
i _!i!i!il ! i_i i¸ i!!
!:
_i_,? _, v>
_
.....
i
i
i
ii
, F
i i
[]
=L ............
1)0
)
Ti L ZSL_ FTr 7
2, 4
i J i_i ¸
SET
1
2
3
144 DOWN
U p _H=,-I
(--
I --)
/i
\
SET
/i
\
_
DOWN
up =H_I
..... ...........
i
]
_sili
ilii_
CLOCK SETrlNG
When the AC cord is connected,
the clock display flashes.
Carry
out the following
steps while the power is off.
1 Press the II SET button to enter the clock setting
mode.
The display indicationbecomesbrightand the "hour"flashes.
2 Press the _1 <1 DOWN or I_ I_ UP button to desig-
nate the hour.
3 Press the II SET button to set the hour.
The "hour" stops flashing and the "minute"
starts flashing.
4 Press the <1 <1 DOWN or I_ I_ UP button to desig-
nate the minute.
Press the II SET button to set the minute and
complete setting.
The minute stops flashing in the display and the clock starts
from 00 second. The display indication becomes dim.
To get a more accurate time, press the
II
SET button at the
desired point, as indicated by another clock or time signal.
Each colon flash in the display indicates a second.
To correct
the current
time --* See illustration
[].
While pressing the SHIFT button, press the CLOCK button on the
remote control. The clock is displayed
for 4 seconds.
Within this period, start correcting
by following
steps 1 to 5.
To switch display to clock while power Is on
While pressing the SHIFT button, press the CLOCK button on the
remote control. The clock is displayed for 4 seconds.
During recording,the clockcannot be displayed.
To switch
to the 24-hour
standard
The time display is factory-set to the 12-hour standard. To switch
to the 24-hour standard, press the CLOCK
button on the remote
control while pressing
the SHIFT button
and then press the •
button within 4 seconds. Repeat the same procedure to restore the
12-hour standard.
If the clock display flashes while the power Is off
This is caused by power interruption. Set the current time again.
14
Publicidad
