Descargar Imprimir esta página

Aiwa NSX-2700 Instrucciones De Manejo página 39

Publicidad

"° ........ _ '°_ ..........
....... _...............
TIMER SETTING
10 m
©
10
®
POWER
I(_STANDBY/O_
/
_t-_" ._. 11"f
j
9 Adjust the volume and tone.
10 Press the POWER
button to turn the unit power off.
Only (_
is displayed, and the unit enters the timer standby
mode. When the timer-on time is reached, the unit is turned on
and play begins in the selected source.
11To listen to the tape or record the source, get ready
for the TAPE function or the timer recording.
To listen to the tape
Press the I_ button.
To record the source
Press the • button on deck 1.
To change the timer-on period
While "TIMER" is displayed for 4 seconds after setting the minute
in step 6, press the <1<1DOWN or I_1=,.UP button to specify the
timer-on period between 10 and 240-minute segments.
You can select the timer-on period in 10-minute steps.
The timer recording period and tape length
When the length of the tape to be recorded is shorter than the timer
recordingperiod, the • button on deck 1is releasedwhenthe timer
is off.
When the tape length islongerthan the timer recordingperiod,the
• button is not released. If the • is not released for a long time,
the tape in the deck may be damaged. Press the • / _ buttonto
release the • button.
To cancel the timer standby mode temporarily
While pressing the SHIFT button, press the TIMER button so that
goes out in the display.
To restore the timer standby mode, press the TIMER button while
pressing the SHIFT button to display (_.
If using the unit after setting the timer
After setting the timer, you can use the unit. After using the unit,
checkwhether the contentsin steps 7 to9 are set as youwish, turn
off the power and set step 11 if necessary.
To change the specified time and function
Repeat all the steps again.
To check the specified contents
While pressing the SHIFT button, press the TIMER button. The
timer-on time is displayed for 4 seconds.
• If the power is on, the timer will not work.
• The timer-on time cannot be set during recording.
• While setting the current time, the timer does not work.
• The connected
equipment
cannot
be turned on and off by the
built-in timer of this unit.
• The timer-on period is not displayed
after setting.
42

Publicidad

loading