Beem Espresso Perfect Crema Plus Manual De Instrucciones página 36

Espresso Perfect Crema Plus
Check the water level in the water
‹
tank (17) and top up if necessary. The
water is required for the generation of
steam.
Switch on the appliance and allow it to
‹
heat up.
Direct the steam nozzle (15) of the
‹
appliance towards the drip tray or an
empty receptacle.
Turn the selector switch (4) to the
‹
Steam generation begins and existing
condensed water is drained off.
Turn the selector switch (4) to the
‹
middle position
escapes continuously from the steam
nozzle (15).
To prepare frothed milk, proceed as fol-
lows:
Fill the froth container up to approxi-
‹
mately one-third with cold milk.
Position the steam nozzle (15) of the
‹
appliance so that the steam nozzle
can protrude into the foaming recep-
tacle.
Immerse the steam nozzle into the
‹
milk in the froth container and turn the
selector switch (4) to the
start frothing.
36

as soon as steam
position to
NOTE
► First of all, hold the steam nozzle
just under the surface of the milk
until the milk in the froth container is
lukewarm.
Subsequently immerse the nozzle
down to the bottom of the froth con-
tainer to swirl the milk.
When the frothed milk has the desired
‹
.
consistency, turn the selector switch
(4) to the middle position
out the froth container from below.
Tap the froth container once or twice
‹
on a firm surface to condense the
frothed milk produced.
Pour or skim the frothed milk into the
‹
drinking receptacle.
Clean the steam nozzle and the metal
‹
tube immediately after use to prevent
deposits and clogging of the steam
nozzle. Instructions on cleaning can
be found in the section Cleaning the
nozzle (page 39).
NOTE
► When steam generation is switched
off, the appliance discharges excess
water into the drip tray.
BEEM - Elements of Lifestyle
EN

and pull