Beem Espresso Perfect Crema Plus Manual De Instrucciones página 41

EN
The following table will help you locate and eliminate minor faults:
fault
The power indicator does
not light up after switch-
ing on.
The automatic circuit
breaker in the electrical
distribution board trips.
Despite pumping noises,
no water comes out of the
appliance
Water runs out on the un-
derside of the appliance
The espresso runs into the
cup very slowly
BEEM - Elements of Lifestyle
Espresso Perfect Crema Plus
Troubleshooting
Possible cause
Not plugged in.
Automatic circuit breaker in
electrical distribution board
tripped.
The signal lamp is defective.
Too many appliances connect-
ed to the same power circuit.
No fault detected.
No water in the tank.
Water tank incorrectly in-
stalled in the housing
Valve on the water tank is
clogged
Drip tray full
Valve on water tank leaking
Coffee powder pressed in too
firmly.
The coffee powder is ground
too finely.
Remedy
Insert the mains plug.
Switch on the automatic
circuit breaker again.
Contact customer
service.
Reduce the number of
appliances on the power
circuit.
Contact customer
service.
Fill with water
Install the water tank
properly.
Clean the valve or allow
to be replaced by cus-
tomer service
Empty the drip tray
Contact customer
service.
Press in the coffee pow-
der less firmly.
Grind the coffee powder
less finely.
41