Operation And Use - Beem Espresso Perfect Crema Plus Manual De Instrucciones

EN

Operation and use

filling the water tank
To fill the water tank (17) of the appliance,
proceed as follows:
Open the lid of the tank (18).
‹
Lift out the water tank (17) using the
‹
black handle.
Fill the tank with the desired amount
‹
of water.
NOTE
► Fill the water tank only up to the
— MAX — mark.
Install the tank (17) in the appliance
‹
again and close the lid (18).
CAUTION
► Do not tilt the water tank when in-
stalling. The valve on the underside
of the water tank may be damaged.
► Make sure that both holders on the
upper edge of the water tank are in-
serted into the recesses on the rear
of the appliance.
Installing the strainer insert
(image A1)
To install the strainer insert, proceed as
follows:
Turn the nib on the wall of the strainer
‹
insert (6) towards the handle and in-
sert the strainer insert into the strainer
holder (7).
Turn the inserted strainer a quarter-
‹
turn to the left or right. The nib pre-
vents the strainer insert from falling
out.
BEEM - Elements of Lifestyle
Espresso Perfect Crema Plus
Removing the strainer insert
(image A1)
To remove the strainer insert, proceed as
follows:
Empty the strainer insert (6) as de-
‹
scribed in the section Emptying/
cleaning the strainer insert (page
38).
Turn the strainer insert (6) so that the
‹
nib on the wall of the strainer insert
is pointing towards the handle and lift
the strainer insert (6) out of the holder
(7).
Emptying the strainer insert
(image B1)
To empty the strainer insert, proceed as
follows:
Fold the retaining bracket on the han-
‹
dle of the strainer holder to the front
over the edge of the strainer insert.
Knock the used coffee powder out of
‹
the strainer insert into the waste con-
tainer.
Fold back the retaining bracket on
‹
the handle of the strainer holder and
clean the strainer insert as described
in the section Cleaning and care
page 38.
NOTE
► Use a spoon if the coffee grounds do
not fall out.
33