Publicidad
Idiomas disponibles
Idiomas disponibles
12.5
Electrical safety
Make sure that the machine is grounded.
•
Only use suitable extension cables.
•
•
A damaged or tangled cable increases the risk of electric shock. Handle the cable with
care. Never use the cable to carry, pull or disconnect the power tool. Keep the cable away
from heat, oil, sharp edges or moving parts.
Proper plugs and outlets reduce the risk of electric shock.
•
Water entry into the machine increases the risk of electric shock. Do not expose the
•
machine to rain or moisture.
The machine may only be used if the power supply is protected by a residual current
•
circuit breaker.
Use the machine only when the ON-OFF switch is in good working order.
•
Before connecting the machine always make sure that it is switches off.
•
12.6
Special safety instructions for woodworking machines
Work with gloves on rotating parts is not permitted!
•
During operation of the machine wood dust is generated. Therefore, connect the machine
•
to a suitable dust collection system for dust and chips during installation!
Always switch on the dust collection system before you start machining the workpiece!
•
•
Never remove sections or other parts of the workpiece from the cutting area while the
machine is running.
When using milling tools with a diameter of ≥ 16 mm and circular saw blades, these must
•
comply with EN 847-1:2013 and EN 847-2:2013; tool carriers must comply with EN 847-3:2013;
Excessive noise can cause hearing damage and temporary or permanent hearing loss. Wear
•
hearing protection certified to health and safety regulations to limit noise exposure.
Replace cracked and deformed saw blades immediately, they cannot be repaired.
•
Use a push stick for cutting operations where less than 120mm is cut, i.e. less than 120mm
•
distance to the right of the saw blade from the rip fence. Do not feed the wood by hand, only
with the push stick!
Select the number of teeth of the saw blade so that at least 2-3 teeth cut through the
•
workpiece at the same time. A lower number of teeth leads on the one hand to an unclean
cut, on the other hand the danger of vibrations and noise pollution increases due to
increased kickback.
12.7
Hazard warnings
Despite its intended use, certain residual risks remain:
•
Risk of injury to fingers and hands from the rotating saw blade if the workpiece is guided
improperly.
Injuries caused by the workpiece being thrown away by improper mounting or guidance,
•
such as working without a stop.
Danger to health from wood dust or chips. It is essential to wear personal protective
•
equipment such as eye protection and a dust mask. Use a dust collection system!
Injuries due to defective saw blade. Check the saw blade regularly for damage.
•
Risk of electric shock if incorrect electrical connections are used.
•
Residual risks can be minimized if the "Safety instructions" and the "Intended use" as well as the
operating instructions are observed.
Due to the design and construction of the machine, hazardous situations may occur when
handling the machines, which are identified as follows in this operating instruction:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
D AN G E R
WAR N I N G
SAFETY
42
TS200 | TS250
Publicidad
